ISSN 2594-5297
56° Seminário de Laminação e Conformação de Metais — vol. 56, num.56 (2019)
Título
Autoria
DOI
Downloads
Resumo
Mathematical models for rolling force calculation during hot rolling are crucial for both automatic mill operation and prediction of steel behavior and of mill capacity, especially for development of new steel grades and improvement of the existing ones. In literature, the models are based usually on the calculation of steel mean flow stress (MFS), firstly, followed by a force model based on MFS. This approach was applied to a large volume of industrial data of coils produced at Usiminas’ plant in Ipatinga, rendering unsatisfactory results. Then, the empirical model developed by Schultz was applied to calculate directly the force, with further fine tuning the model with a linear regression taking into account steel chemical composition. This approach led to force prediction capability better than the traditional models based on the binomial MFS-force presented in literature, markedly for plain CMn steels and IF steels. In such cases, more than 90% of force predictions were inside the ±10% error margin, considering the front stands of hot strip mill.
Mathematical models for rolling force calculation during hot rolling are crucial for both automatic mill operation and prediction of steel behavior and of mill capacity, especially for development of new steel grades and improvement of the existing ones. In literature, the models are based usually on the calculation of steel mean flow stress (MFS), firstly, followed by a force model based on MFS. This approach was applied to a large volume of industrial data of coils produced at Usiminas’ plant in Ipatinga, rendering unsatisfactory results. Then, the empirical model developed by Schultz was applied to calculate directly the force, with further fine tuning the model with a linear regression taking into account steel chemical composition. This approach led to force prediction capability better than the traditional models based on the binomial MFS-force presented in literature, markedly for plain CMn steels and IF steels. In such cases, more than 90% of force predictions were inside the ±10% error margin, considering the front stands of hot strip mill.
Palavras-chave
Hot strip mill; Rolling force; Schultz model
Hot strip mill; Rolling force; Schultz model
Como citar
Santos, Antonio Adel dos;
Barbosa, Jônatas Venâncio.
APPLICATION OF AN EMPIRICAL MODEL FOR ROLLING FORCE CALCULATION IN THE HOT STRIP FINISHING MILL
,
p. 16-26.
In: 56° Seminário de Laminação e Conformação de Metais,
São Paulo,
2019.
ISSN: 2594-5297
, DOI 10.5151/2594-5297-32223
