Anais do Congresso Anual da ABM


ISSN 2594-5327

72nd ABM Annual Congress vol. 72, num.72 (2017)


Título

AVALIAÇÃO DA ADESÃO INTERFACIAL DAS FIBRAS DE COCO E PALF NA MATRIZ EPÓXI POR ENSAIO PULLOUT

EVALUATION OF INTERFACIAL ADHESION OF THE COIR AND PALF FIBERS IN THE EPOXY MATRIX BY PULLOUT TEST

DOI

10.5151/1516-392X-30510

Downloads

Baixar Artigo 347 Downloads

Resumo

Nas últimas décadas, houve um aumento da aplicação de fibras naturais lignocelulósicas (FNLs) como reforços de compósitos poliméricos em diversos setores industriais, principalmente no segmento automotivo. Esse crescente interesse em FNLs se deve não somente aos benefícios ambientais, mas também às vantagens técnicas, econômicas e sociais. Dentre as FNLs, destacam-se as fibras de coco e as fibras da folha do abacaxizeiro (PALF) que são produtos residuais do cultivo de suas respectivas frutas e, por isso, possuem baixo custo e são abundantemente disponíveis. As características físicas dessas fibras se diferem bastante, sendo o PALF caracterizado por suas fibras longas e diâmetro equivalente relativamente baixo. O presente trabalho avaliou o desempenho das fibras de coco e PALF em testes de pullout com o objetivo de caracterizar o comprimento crítico e a adesão interfacial dessas fibras na matriz de epóxi. Os resultados mostraram um comprimento crítico 65% maior para a fibra de coco em relação ao PALF, o que indica maior adesão interfacial do PALF com a matriz epóxi e pode ser atribuída a superfície naturalmente mais rugosa do PALF.

 

Over recent decades, the application of natural lignocellulosic fibers (NLFs) as reinforcements in polymeric composites was increased in several industrial sectors, mainly in automotive segment. This growing interest in NLFs is due not only to environmental benefits but also to technical, economic and social advantages. Among the NLFs, the coir fibers and pineapple leaves fibers (PALF) are byproducts of their fruits cultivation, therefore, these are inexpensive and abundantly available. The physical characteristics of these fibers differ greatly, the PALF are long fibers with relatively low equivalent diameter unlike coir fiber. The present work evaluated the performance of PALF and coir fibers in pullout tests to determine the critical length and the interfacial adhesion of these fibers with epoxy matrix. The results showed a critical length 65% higher for the coir fiber in comparison to PALF, which indicates greater interfacial adhesion of PALF with epoxy matrix and may be attributed to the naturally rougher surface of PALF.

Palavras-chave

Teste de Pullout, Fibras naturais lignocelulósicas, Comprimento crítico, Adesão interfacial.

Pullout test, Natural lignocellulosic fibers, Critical length, Interface adhesion.

Como citar

Luz, Fernanda Santos da; Monteiro, Sergio Neves. AVALIAÇÃO DA ADESÃO INTERFACIAL DAS FIBRAS DE COCO E PALF NA MATRIZ EPÓXI POR ENSAIO PULLOUT , p. 1648-1655. In: 72nd ABM Annual Congress, São Paulo, 2017.
ISSN: 2594-5327 , DOI 10.5151/1516-392X-30510