Anais do Congresso Anual da ABM


ISSN 2594-5327

70º Congresso Anual da ABM vol. 70, num.70 (2015)


Título

AVALIAÇÃO DAS TEMPERATURAS DE TRANSFORMAÇÃO NO DSC EM LIGA NiTi APÓS O ENVELHECIMENTO COM E SEM CARGA

EVALUATION OF THE DSC TRANSFORMATION TEMPERATURES OF NiTi ALLOY AFTER AGING WITH AND WITHOUT THE APPLICATION LOAD

DOI

10.5151/1516-392X-27174

Downloads

Baixar Artigo 729 Downloads

Resumo

Neste trabalho foram usinados CDPs da liga com composição de 50,9 % at de Ni e, em seguida, as amostras foram envelhecidas em temperaturas entre 350-550 ºC, tensões aplicadas de 60 MPa e tempos de 45 e 180 minutos. Além disso, foram realizados também envelhecimento sem aplicação de carga nas mesmas condições de temperatura e tempos para comparação das propriedades, porém acrescentando uma amostra solubilizada a 850ºC durante 1 hora. Posteriormente as amostras foram caracterizadas por DSC para determinação das temperaturas de transformação de fases. Observa-se neste trabalho que o DSC de algumas amostras apresentou tanto no aquecimento quanto no resfriamento dois picos de transformação que pode estar relacionado ao aparecimento da fase R. Além disso, pode ter ocorrido a formação da fase Ni3Ti4, pois ligas com teores acima de 50,6 %at. de Ni são caracterizados pela formação de precipitados ricos em Ni, que pode acarreta na diminuição da concentração de Ni na matriz e aumento da temperatura de transformação. Este trabalho é importante, pois há poucos estudos relacionados com o efeito do envelhecimento sob carga nas propriedades de efeito de memória de forma e superelasticidade da liga NiTi.

 

In this work were machined CDP alloy with composition 50.9 at% Ni, and then the samples were aged at temperatures between 350-550°C, 60 MPa applied voltages and times of 45 and 180 minutes. In addition, aging was also performed without application of load under the same conditions of temperature and time for comparison of properties, but adding a solubilized sample at 850C for 1 hour. Subsequently DSC to determine the phase transformation temperatures characterized the samples. It is observed in this paper that the DSC some samples presented both in heating and in cooling two peaks of transformation that could be related to the onset of phase R. Also, may have been the formation of Ni3Ti4 stage as alloys with levels above at 50.6%at. Ni are characterized by the formation of Nirich precipitates, which may entail a decrease in the concentration of Ni in the matrix and increase the transformation temperature. This work is important because there are few studies related to the effect of aging load the memory effect of shape properties and superelasticity of NiTi alloy.

Palavras-chave

Efeito Memória de forma, Ligas de NiTi, Análise térmica, Envelhecimento sob carga

Shape Memory Alloys, NiTi alloys, Thermal analysis, Aging load

Como citar

Santos, Luiz Alberto dos; Reis, Danieli Aparecida Pereira; Otubo, Jorge. AVALIAÇÃO DAS TEMPERATURAS DE TRANSFORMAÇÃO NO DSC EM LIGA NiTi APÓS O ENVELHECIMENTO COM E SEM CARGA , p. 2524-2532. In: 70º Congresso Anual da ABM, Rio de Janeiro, 2015.
ISSN: 2594-5327 , DOI 10.5151/1516-392X-27174