Título

COMPARISONS OF TRIBOLOGICAL PROPERTIES OF TI(C,N)/SIC IN WATER AND SEAWATER

Autoria

Cermets; Friction; Boundary lubrication; Tribochemistry

Cermets

Eu sou esse autor

Friction

Eu sou esse autor

Boundary lubrication

Eu sou esse autor

Tribochemistry

Eu sou esse autor

DOI

10.5151/1472-5836-25734

Downloads

Resumo

Ti(C,N)-based cermets offer good high temperature strength, perfect chemical stability, excellent wear resistance, and relativly better machinability. In the present work, the tribological behaviors of Ti(C,N)/SiC sliding pairs lubricated in water and seawater were evaluated using a ball-on-disk tribometer. The experimental results show that a relatively low friction coefficient (about 0.025) can be obtained when lubricated with artificial seawater at the sliding speed of 200 mm/s, while the date is about 0.2 in purified water. The wear surface profiles and the lubricants collected after running-in process for the high/low friction conditions were compared. In addition, the effect of salt molar concentration of the lubricant on the Ti(C,N)/SiC friction properties was investigated. It was found that the smooth and flat surface is the premise to gain the low friction. At the same time, the proper concentration of silica colloid, which is affected by the salt ions, is also an essential one. Moreover, the high sliding speed (200 mm/s) is beneficial to achieve low friction.

Palavras-chave

Cermets; Friction; Boundary lubrication; Tribochemistry