Anais do Seminário de Aciaria, Fundição e Metalurgia de Não-ferrosos


ISSN 2594-5300

46º Seminário de Aciaria - Internacional vol. 46, num.46 (2015)


Título

DISCUSSÃO SOBRE O CONCEITO DE CURTO-CIRCUITO APLICADO À ANÁLISE DO ESCOAMENTO DE DISTRIBUIDORES PARA LINGOTAMENTO CONTÍNUO

DISCUSSION ABOUT THE CONCEPT OF SHORT CIRCUIT APPLIED TO FLOW ANALYSIS OF CONTINUOUS CASTING TUNDISHES

DOI

10.5151/1982-9345-26636

Downloads

Baixar Artigo 436 Downloads

Resumo

O curto-circuito é um dos componentes dos modelos de compartimentos utilizados na análise das curvas de Distribuição de Tempos de Residência (DTR) de distribuidores para lingotamento contínuo. Foram identificados na literatura, no entanto, diversos exemplos de seu emprego incorreto. O presente trabalho discute a interpretação física do curto-circuito, as formas de sua quantificação e as consequências nocivas de sua presença sobre a limpidez do aço e o controle da temperatura do aço no molde. Mostra-se que o método de cálculo dos parâmetros dos modelos de compartimentos deve ser alterado caso haja curto-circuito no distribuidor. É constatado que o curto-circuito deve ser evitado durante o projeto de distribuidores destinados à fabricação de aços limpos devido ao risco de perdas metálicas por macroinclusões.

 

Short circuit is one of components of compartment models used in the analysis of Residence Time Distribution (RTD) curves of continuous casting tundishes. It has been identified in the literature, however, several examples of misunderstandings regarding its use. This work discusses the physical interpretation of short circuit, the ways of its quantification and the harmful consequences of its presence on steel cleanness and steel temperature control in the mould. It is shown that the method of calculating parameters of compartment models must be changed if there is a short circuit in the tundish. It is pointed out that the short circuit should be avoided during the tundish design for clean steels producing due to the risk of metal losses by macroinclusions.

Palavras-chave

Distribuidor, Curva DTR, Curto-circuito, Aço limpo

Tundish, RTD curve, Short circuit, Clean steel

Como citar

Braga, Bernardo Martins; Barral, Carlos Eduardo Passagli; Costa, Lucas Teixeira; Tavares, Roberto Parreiras. DISCUSSÃO SOBRE O CONCEITO DE CURTO-CIRCUITO APLICADO À ANÁLISE DO ESCOAMENTO DE DISTRIBUIDORES PARA LINGOTAMENTO CONTÍNUO , p. 354-364. In: 46º Seminário de Aciaria - Internacional, Rio de Janeiro, 2015.
ISSN: 2594-5300 , DOI 10.5151/1982-9345-26636