Anais do Congresso Anual da ABM


ISSN 2594-5327

70º Congresso Anual da ABM vol. 70, num.70 (2015)


Título

INFLUÊNCIA DA DEFORMAÇÃO PLÁSTICA SEVERA NO ENDURECIMENTO POR PRECIPITAÇÃO DE UMA LIGA AA6061

INFLUENCE OF SEVERE PLASTIC DEFORMATION ON PRECIPITATION HARDENING IN AN AA6061 ALLOY

DOI

10.5151/1516-392X-26819

Downloads

Baixar Artigo 358 Downloads

Resumo

Neste estudo uma liga AA6061 foi processada por Extrusão Angular em Canal (EAC) com até quatro passes, a partir de duas condições iniciais diferentes, solubilizada e estabilizada, sendo imposta uma deformação verdadeira de 1,05 a cada passe. As amostras processadas foram caracterizadas através de ensaios de dureza e de análises de calorimetria diferencial de varredura. Tratamentos anisotérmicos foram aplicados após a EAC em condições escolhidas através de calorimetria diferencial de varredura. Observou-se que, devido à microestrutura gerada pela deformação imposta, uma parcela significativa do endurecimento total é obtida após o primeiro passe. As análises de calorimetria diferencial de varredura mostraram que nas amostras deformadas a sequência de precipitação é modificada em relação àquela observada na ausência de deformação, sendo suprimida a formação da fase b¢¢. Ao final dos tratamentos anisotérmicos, observou-se que o valor de dureza das amostras era menor do que o valor inicial, devido à recuperação e à precipitação da fase b¢, menos endurecedora.

 

In the present study an alloy AA6061 was processed by Equal Channel Angular Extrusion (ECAE) with up to four passes from two different initial conditions, assolutionized and stabilized, being imposed a true strain of 1.05 at each pass. The characterization of the processed samples was performed by hardness tests and differential scanning calorimetry. Non isothermal treatments were made after ECAE with conditions chosen by differential scanning calorimetry. It was observed that a significant portion of the total hardening was obtained after the first pass due to the microstructure generated by the imposed deformation. The analysis of differential scanning calorimetry showed that the precipitation sequence in deformed samples is modified relative to that observed in the absence of deformation, due to the phase b¢¢ suppression. At the end of the non isothermal treatments, it was observed that the hardness value of the samples was lower than the initial value due to recovery and precipitation of the less hardening phase b¢.

Palavras-chave

Deformação Plástica Severa, Extrusão Angular em Canal, Ligas Al- Mg-Si

Severe plastic deformation, Equal Channel Angular Extrusion, Al-Mg-Si alloys

Como citar

Guzela, Laércio Rosignoli; Blas, Juan Garcia de. INFLUÊNCIA DA DEFORMAÇÃO PLÁSTICA SEVERA NO ENDURECIMENTO POR PRECIPITAÇÃO DE UMA LIGA AA6061 , p. 1525-1535. In: 70º Congresso Anual da ABM, Rio de Janeiro, 2015.
ISSN: 2594-5327 , DOI 10.5151/1516-392X-26819