Entrar

Anais do Seminário de Laminação, Conformação de Metais e Produtos

ISSN 2594-5297

47º Seminário de Laminação Processos e Produtos Laminados e Revestidos — vol. 47, num.47 (2010)

Título

INSPECTION AT THE EXIT OF A COUPLED PICKLING TANDEM COLD MILL

INSPECTION AT THE EXIT OF A COUPLED PICKLING TANDEM COLD MILL

Autoria

Deschamps, Olivier

Deschamps, Olivier
Deschamps, Olivier

Eu sou esse autor

DOI

10.5151/2594-5297-17245

Downloads

Baixar Artigo 165 Downloads

Resumo

The new Siemens VAI PLTCM installed at Corus (Ijmuiden, Netherlands) has been provided with a SIROLL SIAS surface inspection system installed at the exit of the rolling mill. The challenge was to ensure a perfect surface inspection in the tough environmental conditions at the exit of a PLTCM. The article describes the solutions implemented and the results obtained.

 

The new Siemens VAI PLTCM installed at Corus (Ijmuiden, Netherlands) has been provided with a SIROLL SIAS surface inspection system installed at the exit of the rolling mill. The challenge was to ensure a perfect surface inspection in the tough environmental conditions at the exit of a PLTCM. The article describes the solutions implemented and the results obtained.

Palavras-chave

Surface inspection; Flat strip; Tandem mill; SIAS.

Surface inspection; Flat strip; Tandem mill; SIAS.

Como citar

Deschamps, Olivier. INSPECTION AT THE EXIT OF A COUPLED PICKLING TANDEM COLD MILL , p. 43-49. In: 47º Seminário de Laminação Processos e Produtos Laminados e Revestidos, Rio de Janeiro, 2010.
ISSN: 2594-5297 , DOI 10.5151/2594-5297-17245