ISSN 2594-5327
65º Congresso ABM — vol. 65, num.65 (2010)
Título
Autoria
DOI
Downloads
Resumo
The steel of this work, 0.06C-25Mn-3Al-2Si-1Ni steel, presenting TWIP effect, was hot and cold rolled and then annealed at temperatures between 600 and 850oC. The microstructure examination was focused in the recrystallization during annealing for different temperatures through optical and scanning electron microscopy. The volume fraction and recrystallized grain size measurements were performed. Tensile tests were conducted at room temperature. A polycrystalline model, based on micromechanics and working hardening theory, developed by Bouaziz et al., to predict the behavior of TWIP steels under different loading paths, was applied to current steel. The results from the model are in good agreement with mechanical test and show a total elongation above 60%, uniform elongation up to 0.55 and a tensile strength over than 600 MPa, which highlights the potential of steel for its various applications, mainly automotive industry. The model parameters are discussed and their limitations are presented.
The steel of this work, 0.06C-25Mn-3Al-2Si-1Ni steel, presenting TWIP effect, was hot and cold rolled and then annealed at temperatures between 600 and 850oC. The microstructure examination was focused in the recrystallization during annealing for different temperatures through optical and scanning electron microscopy. The volume fraction and recrystallized grain size measurements were performed. Tensile tests were conducted at room temperature. A polycrystalline model, based on micromechanics and working hardening theory, developed by Bouaziz et al., to predict the behavior of TWIP steels under different loading paths, was applied to current steel. The results from the model are in good agreement with mechanical test and show a total elongation above 60%, uniform elongation up to 0.55 and a tensile strength over than 600 MPa, which highlights the potential of steel for its various applications, mainly automotive industry. The model parameters are discussed and their limitations are presented.
Palavras-chave
TWIP effect, Annealing, Modeling and Simulation.
.
Como citar
Spindola, Mirelle Oliveira;
Ribeiro, Érica Aparecida Silva;
Gonzalez, Berenice Mendonça;
Santos, Dagoberto Brandão.
MODELING OF WORK HARDENING BEHAVIOUR OF HIGH Mn AND LOW C POLYCRISTALLINE AUSTENITIC STEEL WITH TWIP EFFECT
,
p. 5240-5249.
In: 65º Congresso ABM,
Rio de Janeiro,
2010.
ISSN: 2594-5327
, DOI 10.5151/2594-5327-33726
