Título

THE LEADING HOT METAL DESULFURIZATION METHODS: A COMPARISON BETWEEN KR, MMI AND CO-INJECTION

Autoria

Schrama, Frank; Hattum, Guido van; Berg, Bart van den

Schrama, Frank

Eu sou esse autor

Hattum, Guido van

Eu sou esse autor

Berg, Bart van den

Eu sou esse autor

DOI

10.5151/1982-9345-26624

Downloads

Resumo

Steelmakers worldwide agree that the most efficient and cost-effective solution in BOF steelmaking is to desulfurize the hot metal between the blast furnace and converter. Various methods are currently in use, among which the Kanbara Reactor (KR, using only lime as a reagent), Magnesium mono-injection (MMI, using only magnesium; also known as the Ukraina-Desmag process) and co-injection (using magnesium and lime/CaC2) are leading. These three hot metal desulfurization methods are compared based on metallurgy, efficiency, costs and overall performance. Both available data from literature and experience from Danieli Corus engineers is used for this study. The KR process is able to reach low sulfur concentrations (> 10 ppm) in hot metal and has lower reagent costs. However, due to higher Fe-loss and heavy wear the KR process has the highest operational costs. The Magnesium mono-injection process is very fast due to the use of the reactive magnesium as reagent. Major problems with resulfurization (sulfur levels below 50 ppm cannot be reached) and the violence of the process made that this process could never get a firm foothold in the western steel industry. The co-injection process with magnesium and lime proves to be able to combine the best of both worlds. It can reach low sulfur concentrations and desulfurize fast. Co-injection is also the most flexible and cost effective.

Palavras-chave

Hot metal desulfurization, Co-injection, Kanbara reactor, Magnesium mono-injection

Magnesium mono-injection