Anais do Congresso Anual da ABM


ISSN 2594-5327

68º Congresso da ABM vol. 68, num.68 (2013)


Título

AVALIAÇÃO DO DANO POR FADIGA NO AÇO SAE 8620 UTILIZANDO MEDIDA DE RESISTÊNCIA ELÉTRICA

FATIGUE DAMAGE EVALUATION ON STEEL SAE 8620 USING ELECTRICAL RESISTANCE MEASUREMENTS

DOI

10.5151/2594-5327-23019

Downloads

Baixar Artigo 743 Downloads

Resumo

Fadiga é uma forma de falha que ocorre em estruturas que estão sujeitas a tensões dinâmicas e cíclicas, e a falha ocorre, geralmente, a uma tensão inferior ao limite de escoamento do material. A falha por fadiga ocorre repentinamente, sem qualquer aviso prévio. Mesmo nos metais dúcteis, a falha por fadiga é de natureza frágil, apresentando pouca ou nenhuma deformação plástica. A falha do material testado em fadiga ocorre pelo acúmulo de danos no material. O objetivo deste trabalho é determinar a nucleação e a propagação no acúmulo de danos, utilizando ensaios de fadiga mecânica e medidas de variação de resistência elétrica no corpo de prova testado, antes do colapso. Para atingir este objetivo foram realizados ensaios de fadiga flexo-rotativa em corpos de prova de aço SAE 8620, e realizado medidas de resistência elétrica antes do teste e após determinados números de ciclos testados, durante todo o ensaio antes da falha por fadiga, e importante, sem retirar o corpo de prova do equipamento de fadiga. A procura de método para medir ou avaliar o acúmulo de danos em materiais sujeitos à fadiga é de primordial importância para segurança e integridade da estrutura, tentando detectar dano antes que ocorram falhas catastróficas.

 

Fatigue is a failure that occurs in structures that are submitted to dynamic and cyclic stress, and the failure occurs, usually, under a lower stress than yield stress of the material. A fatigue failure occurs suddenly, without any pre notice. Even on ductile metal, the fatigue failure is fragile and has little or any plastic deformation. The fatigue failure occurs by damages accumulation on the material. The purpose of the work is to determine the nucleation and the propagation on the damages, necessary to damage accumulation, using mechanical fatigue tests and the changing of electrical resistance, before of the collapse. To achieve this purpose, flexo-rotative fatigue tests in SAE 8620 steel specimens and electrical resistance measurements were accomplished, before and after a defined number of cycles. The specimens during all the test of fatigue were not withdrawn of machine before the fatigue failure. The electrical resistances were done in specimens mounted in fatigue equipment. The search of a method to measure or evaluate the damages accumulation in materials under fatigue has great importance to security and integrity of the structure, trying to detect damage before catastrophic or fragile failure occurs.

Palavras-chave

Fadiga mecânica; Dano; Resistência elétrica; Integridade estrutural.

Mechanical fatigue; Damage; Electrical resistance; Structural integrity.

Como citar

Martins, Kétsia dos Santos; Lorenzo, Roberto Francisco Di. AVALIAÇÃO DO DANO POR FADIGA NO AÇO SAE 8620 UTILIZANDO MEDIDA DE RESISTÊNCIA ELÉTRICA , p. 1238-1247. In: 68º Congresso da ABM, São Paulo, 2013.
ISSN: 2594-5327 , DOI 10.5151/2594-5327-23019