ISSN 2594-5327
65º Congresso ABM — vol. 65, num.65 (2010)
Título
Autoria
DOI
Downloads
Resumo
In this work is shown the influence of some deformation processes on the mechanical and microstructure of initially annealed 6063 Al alloy (cold rolling or torsion or extrusion and also tensile deformation, individually or a combination of them). The combination of strength and toughness is intimately related to the work hardening. The analysis and control of work hardening has proven to be one of the problems of materials science due to the complexity of the dislocation processes involved and the non homogeneity of their operation within the deforming microstructure together with presence of a multiphase microstructure on the 6063 aluminum alloy (Al-Mg-Si-Fe). During deformation, particles will affect the deformation microstructure and texture (heterogeneities at larger particles; non homogeneity of slip, e.g. shear bands). The obtained results indicate a significant effect of second-phase particles on recrystallization and how to control the resulting microstructure and texture by the use of particles.
In this work is shown the influence of some deformation processes on the mechanical and microstructure of initially annealed 6063 Al alloy (cold rolling or torsion or extrusion and also tensile deformation, individually or a combination of them). The combination of strength and toughness is intimately related to the work hardening. The analysis and control of work hardening has proven to be one of the problems of materials science due to the complexity of the dislocation processes involved and the non homogeneity of their operation within the deforming microstructure together with presence of a multiphase microstructure on the 6063 aluminum alloy (Al-Mg-Si-Fe). During deformation, particles will affect the deformation microstructure and texture (heterogeneities at larger particles; non homogeneity of slip, e.g. shear bands). The obtained results indicate a significant effect of second-phase particles on recrystallization and how to control the resulting microstructure and texture by the use of particles.
Palavras-chave
6063-aluminum alloy, deformation processes, Microstructure, second- phase particles
6063-aluminum alloy, deformation processes, Microstructure, second- phase particles
Como citar
Monteiro, Waldemar Alfredo;
Buso, Sidnei José;
Ferrari, Ricardo Bulcão;
Esposito, Iara Maria;
Cetlin, Paulo Roberto;
Corrêa, Maria T. P. Aguillar Elaine C. S.;
, .
MECHANICAL AND MICROSTRUCTURAL ASPECTS OBSERVED IN 6063 ALUMINUM ALLOY AFTER THERMOMECHANICAL TREATMENTS
,
p. 5212-5219.
In: 65º Congresso ABM,
Rio de Janeiro,
2010.
ISSN: 2594-5327
, DOI 10.5151/2594-5327-33586
