Powered by Blucher Proceedings

Anais do Congresso Anual da ABM


ISSN 2594-5327

64º Congresso Anual da ABM Vol. 64, Num. 64 (2009)


Título

CORRELAÇÃO ENTRE ENSAIOS DE DESGASTE ABRASIVO REALIZADOS EM LABORATÓRIO

CORRELATION AMONG ABRASIVE WEAR TESTS DONE IN LABORATORY

Autoria

DOI

10.5151/2594-5327-15163

Downloads

131 Downloads

Resumo

Nesse trabalho, verificou-se a correlação entre os resultados de taxas de desgaste obtidos entre três ensaios abrasivos distintos: um representado um mono-evento abrasivo – esclerometria pendular, o segundo representado um ensaio a dois corpos – pino-lixa e, finalmente, o terceiro a três corpos – ensaio LTM. Foram comparadas oito ligas, sendo três ligas de ferro fundido branco alto cromo e cinco ligas de alumínio- silício. A relação entre os ensaios, materiais e taxas de desgaste foi, então, observada. Verificou-se que o ensaio de esclerometria pendular é inversamente relacionado com os resultados do ensaio pino-lixa, apesar de serem aparatos que produzem, a priori, eventos severos. Verificou-se, também, uma correlação direta entre o ensaio LTM e o ensaio de esclerometria pendular.

 

In this study, it was observed the wear rate correlation of three severe abrasive wear tests. Eight alloys, three chromium white cast irons and five aluminum-silicon alloys were tested in three different severe abrasive wear tests. The first test, represents a single abrasive event - single-pass pendulum, the second, represents a two body abrasive wear test - pin-on-disk, and the third represents a three body abrasive wear test - LTM test. The correlation among this tests, materials and wear rates were then observed. It was verified that the single-pass pendulum test has a negative correlation with the pin-on-disk test although both represent, at first, severe events. It was also verified that the LTM test has a positive correlation with the single-pass pendulum.

Palavras-chave

Desgaste abrasivo; Correlação; Taxa de desgaste.

Abrasive wear; Correlation; Wear rate.

Como citar

Dutra, Leandro Almeida; Bozzi, Antônio Cesar; Mello, José Daniel Biasoli de; Scandian, Cherlio. CORRELAÇÃO ENTRE ENSAIOS DE DESGASTE ABRASIVO REALIZADOS EM LABORATÓRIO, p. 2966-2975. In: 64º Congresso Anual da ABM, Belo Horizonte, 2009.
ISSN: 2594-5327, DOI 10.5151/2594-5327-15163