ISSN 2594-5327
49º Congresso anual — Vol. 49, Num. 1 (1994)
Título
Autoria
DOI
Downloads
Resumo
The manufacturing technology of corrosion resistant alloy (CRA) clad UOE pipe for pipelines transporting oil and gas containing H₂S, CO₂ and other chemicals has been studied. The required corrosion resistance of the CRA layer was achieved in the as-rolled condition by optimizing the thermomechanical control process (TMCP) conditions for manufacturing the clad plate. In order to obtain good corrosion resistance in the CRA layer, it is necessary to ensure complete recrystallization and suppress the precipitation of chromium carbides in the CRA layer after rolling. To this end the clad plate was finish-rolled at high temperature and water-cooled after air cooling. However, in conventional steel high temperature rolling causes a considerable deterioration in the low-temperature toughness, therefore, a low C-high Nb-Ti microalloyed steel, which exhibits a fine-grained microstructure even under high temperature rolling, was developed for the base material of CRA clad UOE pipe.
Palavras-chave
CRA clad pipe, TMCP, corrosion resistance, recrystallization, microalloyed steel
Como citar
Tamehiro, H.; Terada, Y.; Ogata, Y.; Gray, J.M.; Yoshino, T.; Hirokawa, T.; Katayama, K.; Ogawa, H.; Horii, Y.; Uemori, R.; Kashimura, H..
CRA Clad UOE Pipe Produced by Applying TMCP Plate,
p. 3949-3962.
In: 49º Congresso anual,
Rio de Janeiro, Brasil,
1994.
ISSN: 2594-5327, DOI 10.5151/2594-5327-49v8-431-444
