Powered by Blucher Proceedings

Anais do Congresso Anual da ABM


ISSN 2594-5327

71º Congresso Anual da ABM Vol. 71, Num. 71 (2016)


Título

FABRICAÇÃO DE COMPÓSITOS DE MATRIZ POLIÉSTER REFORÇADA COM TECIDO DE JUTA APLICADOS EM BLINDAGEM MULTICAMADA

FABRICATION OF POLYESTER MATRIX COMPOSITES REINFORCED WITH JUTE CLOTH APPLIED IN MULTILAYERED ARMOR

Autoria

DOI

10.5151/1516-392X-27930

Downloads

470 Downloads

Resumo

Este trabalho visa apresentar os resultados obtidos através de ensaios balísticos realizados em sistemas de blindagem multicamada. Seguindo as especificações da norma americana NIJ 0101.06, foram realizados ensaios utilizando munição de calibre 7,62x 51 mm, que possui velocidade acima de 800 m/s. A blindagem multicamada utilizada possui como camada frontal uma pastilha hexagonal cerâmica (alumina dopada com 4% de nióbia), segunda camada de compósito de matriz poliéster reforçada com tecido de juta e como terceira camada uma placa de alumino 5052 H34. A utilização de compósitos poliméricos reforçados com fibras naturais em substituição às fibras de aramida é de grande interesse, pois além de desempenharem a mesma função no sistema de blindagem, possuem um valor de mercado bem menor. Os resultados de profundidade de indentação na plastilina foram satisfatórios visto que atenderam a norma NIJ 0101.06 e utilizando a técnica de microscopia eletrônica de varredura, verificou-se que o compósito poliéster-juta capturou os fragmentos através do mecanismo de incrustação mecânica.

 

This paper presents some results obtained through ballistic tests on Multilayered Armor System (MAS). Following the specifications of American standard NIJ 0101.06, the tests were realized with ammunition 7.62 x 51 mm that has a velocity above of 800 m/s. The MAS is composed of a front layer a hexagonal ceramic chip (alumina doped with 4% of nióbia), the second layer of polyester matrix composite reinforced with cloth of jute and the third layer an aluminum plate 5052 H34. The utilization of polymeric composites reinforced with natural fibers to replace the aramid fibers is the big interest because they perform the same function in the armor system with the less expensive. The results of depth of indentation in clay witness were satisfactory because they have attended the standard NIJ 0101.06 and the scanning electron microscopy technique has showed that the polyester-jute composite has captured those fragments through of mechanism of mechanic incrustation.

Palavras-chave

Blindagem multicamada, compósito poliéster-juta, ensaio balístico

Multilayered armor, polyester-jute composite, ballistic tests

Como citar

Ferreira, Daniel Fernandes; Machado, Amon Rhaniery Brito; Monteiro, Sergio Neves; Pereira, Artur Camposo; Assis, Foluke Salgado de; Magalhães, Kessy Jhonnes Matheus Marques; Gabriel, Felipe Magalhães de Matos; Nascimento, Daniel Neri Nogueira do. FABRICAÇÃO DE COMPÓSITOS DE MATRIZ POLIÉSTER REFORÇADA COM TECIDO DE JUTA APLICADOS EM BLINDAGEM MULTICAMADA, p. 1067-1074. In: 71º Congresso Anual da ABM, Rio de Janeiro, 2016.
ISSN: 2594-5327, DOI 10.5151/1516-392X-27930