ISSN 2594-5327
49º Congresso anual — Vol. 49, Num. 1 (1994)
Título
Autoria
DOI
Downloads
Resumo
In the paper two own original ways for metal flow control within deformation zone during direct extrusion are presented. Regulation of metal flow in the first one takes place by application of a mandrel situated at a proper distance of a die. In the second technique the metal flow control is realized using so-called convex dies of appropriate design. The effectiveness of suggested methods was examined in the laboratory and industrial trials. In the industrial trials aluminium alloy AA 2017 was extruded using hydraulic presses of 12.5 and 25 MN capacity. The results, concerning the influence of extrusion mode on the product structure, maximum permissible exit speed and extrusion force, were compared with those for traditional direct extrusion.
Palavras-chave
metal flow control, extrusion, mandrel, convex die, aluminium alloy
Como citar
LIBURA, WOJCIECH; ZASADZINSKI, JOZEF; MISIOLEK, WOJCIECH Z..
METAL FLOW CONTROL IN EXTRUSION,
p. 2779-2786.
In: 49º Congresso anual,
Rio de Janeiro, Brasil,
1994.
ISSN: 2594-5327, DOI 10.5151/2594-5327-49v6-231-238
