ISSN 2594-5327
49º Congresso anual — Vol. 49, Num. 1 (1994)
Título
Autoria
DOI
Downloads
Resumo
Aluminium–silicon alloy (JIS-AC8A) matrix composites reinforced with SiC particles (10% in vol.) were fabricated by centrifugal spray forming process, and the microstructure of the powders and the preforms produced were investigated. Aluminium alloy droplets solidified during flight show fine well defined dendritic structures, but the pre-solidified droplets of aluminium alloy reinforced with SiC particulates exhibit fine equiaxed grain structures. Eutectic silicon is crystallized at the corner of the fine aluminium grains, and some SiC particles seem to act as nucleation sites for pro-eutectic silicon during solidification of aluminium alloy. Such pro-eutectic silicon seem to retard grain growth during spray forming process. The microstructure of composite powders formed by centrifugal spray forming process exhibit particle embedded type, and result in dispersed type, microstructure in preforms deposited. The deposited preforms of SiC reinforced Al-Si alloy MMC exhibits finer equiaxed grain structure than that of unreinforced Al-Si alloy.
Palavras-chave
Aluminium-silicon alloy, SiC particles, Centrifugal spray forming, Microstructure, Metal matrix composites
Como citar
PARK, JONGSUNG; BAE, CHAHURN; KIM, MYUNGHO.
MICROSTRUCTURE OF PARTICLE REINFORCED METAL MATRIX COMPOSITES PRODUCED BY CENTRIFUGAL SPRAY FORMING PROCESS,
p. 4416-4429.
In: 49º Congresso anual,
Rio de Janeiro, Brasil,
1994.
ISSN: 2594-5327, DOI 10.5151/2594-5327-49v9-327-340
