ISSN 2594-5300
31º Seminário de Aciaria — Vol. 01 , num. 31 (2000)
Título
Autoria
DOI
Downloads
Resumo
The selection of charge materials, lance operation, lance tip design and bottom stirring are the important criteria by means of which the LD-process can be monitored and controlled. This paper demonstrates the effects of the individual components on the process as a whole, and shows the mutual influences and dependencies of the factors discussed. The aim of the present discussion is to explain the processes taking place in the LD-converter and to suggest ways of improving the processes where problems arise.
The selection of charge materials, lance operation, lance tip design and bottom stirring are the important criteria by means of which the LD-process can be monitored and controlled. This paper demonstrates the effects of the individual components on the process as a whole, and shows the mutual influences and dependencies of the factors discussed. The aim of the present discussion is to explain the processes taking place in the LD-converter and to suggest ways of improving the processes where problems arise.
Palavras-chave
LD-(BOF-) process, Lance tip design, Bottom stirring, LD blowing technique, LD slag formation, Lance skulls
LD-(BOF-) process, Lance tip design, Bottom stirring, LD blowing technique, LD slag formation, Lance skulls
Como citar
Bock, Manfred; Schoop, Josef; Oehler, Christian.
THE INFLUENCE OF BLOWING TECHNIQUES, BOTTOM STIRRING AND LANCE DESIGN IN THE LD-PROCESS ON SLAG FORMATION, THE FORMATION OF LANCE AND CONVERTER SKULLS AND CONVERTER LINING LIFE,
p. 265-280.
In: 31º Seminário de Aciaria,
Rio de Janeiro, Brasil,
2000.
ISSN: 2594-5300, DOI 10.5151/2594-5300-31Aciaria-265-280
