Anais do Congresso Anual da ABM


ISSN 2594-5327

73º Congresso Anual da ABM vol. 73, num.73 (2018)


Título

ANÁLISE DO REVESTIMENTO DE CROMO EM ELETRODOS DE SOLDA A PONTO POR RESISTÊNCIA EM LIGAS DE ZIRCÔNIO

ANALYSIS OF CHROME COATING OF RESISTENCE SPOT WELDING ELECTRODES IN ZIRCONIUM ALLOYS

DOI

10.5151/1516-392X-241

Downloads

Baixar Artigo 173 Downloads

Resumo

Um processo de união dos componentes que compõe a estrutura de um combustível nuclear é a soldagem a ponto por resistência elétrica. Os componentes soldados são chapas e tubos de fabricados de ligas de Zircônio, que é conhecido por sua secção de choques a neutros ser muito baixa e por sua temperatura de fusão muito alta. Devido à alta temperatura de fusão, a faixa de soldas aceitáveis é pequena. Para uma abertura desta faixa de trabalho, foi proposta a inclusão de uma camada micrométrica de cromo na superfície do eletrodo de cobre. O cromo tem uma temperatura de fusão maior do que o cobre, e por esse motivo protege o eletrodo e não altera significativamente o fluxo elétrico. Foram avaliados testes de corrosão e ensaios micrográficos para comprovar um ganho de faixa de trabalho e consequente aumento do volume da lentilha de solda

 

One of the joining processes of the metal components that make up the structure of a nuclear fuel is the RSW (Resistance Spot Welding). The components that are welded are sheets and tubes made of Zirconium alloys. It is known for a low neutron-capture cross-section and its melting temperature too high. Since of the high melt temperature, the range of acceptable welds is small. To increase this working range, a coating of chromium was tested on the surface of the electrode. Chromium has a higher melting temperature than the copper therefore protects the electrode and does not significantly change the electric flux because the layer is a micrometric. For the evaluation of the increase of working range, metallographic tests were used to determine the lentil size and the corrosion tests were used either.

Palavras-chave

Zircônio; Solda a Ponto; Energia Nuclear

Zirconium; Resistance Spot Welding; Nuclear Energy.

Como citar

Meireles, João Batista; Castro, José Adilson de. ANÁLISE DO REVESTIMENTO DE CROMO EM ELETRODOS DE SOLDA A PONTO POR RESISTÊNCIA EM LIGAS DE ZIRCÔNIO , p. 2365-2374. In: 73º Congresso Anual da ABM, São Paulo, 2018.
ISSN: 2594-5327 , DOI 10.5151/1516-392X-241