Proceedings of the Ironmaking, Iron Ore and Agglomeration Seminars

Title

AN INTRODUCTION TO DUSTCLONE TECHNOLOGY AND THE BENEFITS OFFERED

Authorship

Mawer, Robert Paul; Harvey, Richard

Mawer, Robert Paul

I am this author

Harvey, Richard

I am this author

DOI

10.5151/2594-357X-33258

Downloads

Abstract

In recent times there has been an increase in the demand from Steel plants for a technology that offers the most economical environmentally sustainable solution. In terms of blast furnace off gas cleaning this has seen a drive towards Cyclone technology replacing the older Dustcatchers. Cyclone technology can achieve dust removal efficiencies as high as 95% increasing the dust yield at the primary stage of gas cleaning. The dry dust (rich in Fe and C) can then be recycled to the Sinter Plant or Blast Furnace. Capture of dust at this stage also has the benefit that sludge generation from the secondary stage is also reduced meaning less waste to landfill and / or recovery of some of the by-products for further use. Primetals Technologies already offer a state of the art Tri-Axial Cyclone installed on many sites world-wide, however, this paper focuses on a hybrid of this technology, the DustClone. The DustClone is a low CAPEX unit that is essentially a Cyclone housed inside the Dustcatcher. This unit is aimed at operators who may be carrying out smaller scaled shutdowns / repairs that normally have a reduced CAPEX. This paper describes the technology that Primetals Technologies have developed.

Keywords

DustClone; Dustcatcher; Cyclone; Dust Recycling