Proceedings of the Ironmaking, Iron Ore and Agglomeration Seminars


ISSN 2594-357X

Title

ASSESSMENT TECHNIQUES FOR MEASURING TENSILE ADHESIVE FORCES OF WET AND STICKY ORES

DOI

10.5151/2594-357X-27672

Downloads

Abstract

Economic drives dictate the exploitation of formerly less attractive ore bodies located close to or even beneath the water table. These ores can cause handling problems and expensive downtime of processing equipment due to their increased adhesive characteristics and are colloquially termed as “wet and sticky” ores. In order to gain a better understanding of the causes of poor handleability, experimental test methods for wall and inter-particle adhesion within bulk solids samples were developed and validated. The results confirmed that adhesion of bulk solid to equipment surfaces is mainly governed by capillary pressure. It can therefore be described using the Young-Laplace equation, which implies that adhesion is primarily dependent on the interfacial water between bulk material and the adhesion partner. Accordingly, the governing material parameters of adhesion are its capillarity and permeability, as these two characterize water transport to or from the interface of the adhesion partners. Furthermore a threshold for the classification of a material as wet and sticky based on the measurements of adhesion has been proposed.

 

Keywords

Bulk solids, Adhesion, Wets and sticky ores, Materials handling

Materials handling

How to refer

Williams, Kenneth; Plinke, Jens; Chen, Wei. ASSESSMENT TECHNIQUES FOR MEASURING TENSILE ADHESIVE FORCES OF WET AND STICKY ORES , p. 154-158. In: 46º Seminário de Redução/ 17º Minério de Ferro/ 4º Aglomeração, Rio de Janeiro, 2016.
ISSN: 2594-357X , DOI 10.5151/2594-357X-27672