ISSN 2594-5327
62º Congresso anual da ABM — Vol. 62, Num. 62 (2007)
Title
DOI
Downloads
Abstract
Na prática as tensões desenvolvidas na interface são difíceis de serem determinadas principalmente devido às dificuldades em se medir a área de contato cavaco-ferramenta. A literatura descreve poucos métodos ou critérios a serem empregados na estimativa da área de contato. Trabalhos recentes sugerem a pintura da face da ferramenta com tintas de canetas de retroprojetor. Embora este método tenha sido reportado com êxito, existe a possibilidade de evaporação da tinta durante o corte. Este trabalho visa determinar experimentalmente a área de contato sendo proposta a utilização de uma ferramenta de metal-duro cuja última camada de revestimento (nitreto de titânio) sobre a face da ferramenta de corte favorece a visualização do desgaste após um breve tempo de corte. A delimitação da área de contato foi feita através de análise visual, apoiada por um software de análise de imagens, com a demarcação das regiões onde ocorreu a perda do revestimento de nitreto de titânio. Foi estabelecido um tempo de corte suficiente para obter uma região de contato bem demarcada e assim estimar quantitativamente a área de contato no torneamento do ferro fundido nodular ferrítico. Foram obtidos resultados para as velocidades de corte 150, 200 e 250 m/min e avanços 0,2 e 0,25 mm.
The difficulties found to experimentally determine the area established by the contact between chip and tool do not allow to estimate with precision the stresses actuating on the interface chip- cutting tool. The literature describes few methods or criteria to be employed in contact area estimation. Recent works suggest painting of the tool face with ink from pens used in overhead projector transparency film. Although this method has been reported successfully, there is the possibility of evaporation of the ink during cutting. This work aims to determine experimentally the contact area, being proposed the utilization of a tool in hard metal whose last coat layer (titanium nitride) on the face of the cutting tool favors the viewing of the wear after a brief cutting time. The delimitation of the contact area was done through visual analysis, supported by a image analyzing software, with delimitation of the regions where a loss of titanium nitride happened. A sufficient cutting time was established to obtain a well delimited contact region, and thus quantitatively estimate the contact area in turning of ferritic nodular cast iron. Results for cutting speeds 150, 200 and 250 m/min and feed rates 0,2 and 0,25 mm were obtained.
Keywords
Área de contato; Interface cavaco-ferramenta.
Contact area; Interface chip-cutting tool.
How to cite
Lucas, Eliene Oliveira; Weingaertner, Walter Lindolfo.
DETERMINACÃO EXPERIMENTAL DA ÁREA DE CONTATO, COM FERRAMENTAS DE METAL-DURO REVESTIDAS, NO TORNEAMENTO DO FERRO FUNDIDO NODULAR FERRÍTICO GGG 42 (DIN 1663,
p. 4495-4503.
In: 62º Congresso anual da ABM,
Vitória,
2007.
ISSN: 2594-5327, DOI 10.5151/2594-5327-0483