Other events

Title

DYNAMIC TRANSFORMATION DURING PLATE ROLLING SIMULATIONS OF A HIGH NB STEEL

Authorship

Rodrigues, Samuel Filgueiras; Siciliano, Fulvio; Jr., Clodualdo Aranas; Silva, Eden Santos; Reis, Gedeon Silva; Jonas, John Joseph

Rodrigues, Samuel Filgueiras

2 Articles, Downloaded 364 Times

Siciliano, Fulvio

I am this author

Jr., Clodualdo Aranas

I am this author

Silva, Eden Santos

I am this author

Reis, Gedeon Silva

I am this author

Jonas, John Joseph

I am this author

DOI

10.5151/9785-9785-32210

Downloads

Abstract

When austenite is deformed above the Ae3 temperature, partial amount of it transforms dynamically into ferrite by a displacive mechanism. After unloading, it retransforms back into the stable austenite by a diffusional process. This influences the rolling load which decreases under isothermal condition or does not increase with decreasing temperature as rapidly as expected. Plate rolling simulations under isothermal and continuous cooling conditions were carried out on a 0.09 wt.% Nb X-70 steel. Pass strains of 0.2 were employed together with interpass times of 10 s, and 30 s for the cooling conditions and 0.3 with interval of 10 s at 900 °C for the isothermal experiments; strain rate of 1 s-1 was used during the simulations. The mean-flow-stress (MFS`s) behavior of both conditions indicates that dynamic transformation and dynamic recrystallization were taking place during straining. The critical strains for the initiation of dynamic transformation fell around 0.06 while the critical strain for DRX was 0.12. It has been shown that ferrite is formed due to the applied deformation of roughing passes and increases its volume fraction throughout the finishing rolling stage. Under cooling conditions, the ferrite formation is also favored as the temperature approaches the Ae3 line. Such ferrite forms when the driving force for dynamic transformation is higher than the total free energy barrier preventing its formation. This obstacle consists of the free energy difference between austenite and ferrite as well as the lattice dilatation work and shear accommodation work. The addition of Nb retards the retransformation of the ferrite into austenite. Moreover, holding times after rolling increases the amount of austenite available for microstructure control on subsequent stages. The dynamic transformation (DT) mechanism can be used to design improved rolling schedules.

Keywords

Dynamic transformation; High Nb steel; Plate rolling simulation