Powered by Blucher Proceedings

Proceedings of ABM Annual Congress


ISSN 2594-5327

69th ABM International Annual Congress Vol. 69, Num. 69 (2014)


Title

INFLUÊNCIA DO TRATAMENTO TÉRMICO NAS TEMPERATURAS DE TRANSFORMAÇÃO DE LIGA Ni-Ti-Cu SOLIDIFICADA RAPIDAMENTE COM EFEITO DE MEMÓRIA DE FORMA

THE EFFECT OF THE HEAT TREATMENT ON TRANSFORMATION TEMPERATURES IN RAPIDLY SOLIDIFIED Ti-Ni-Cu SHAPE MEMORY ALLOY

Authorship

DOI

10.5151/1516-392X-24596

Downloads

292 Downloads

Abstract

O efeito de memória de forma tem como principal objetivo a recuperação da forma por meio de aquecimento acima das temperaturas críticas de transformação. Fitas da liga Ti43,5Cu37,8Ni18,7 foram preparadas através do processo melt spinnig com velocidade da roda de 21 m/s e 63 m/s. As fitas foram tratadas termicamente numa temperatura de 700°C por 15 minutos em forno e resfriadas ao ar. A caracterização das fitas foi feita por calorimetria diferencial de varredura (DSC) e análise por difração de raios X (DRX). Foi observado que com uma menor velocidade de rotação da roda (21 m/s) a fita apresentou-se totalmente cristalina, e quando aumentou-se a velocidade linear da roda para 63 m/s a fita apresentou-se completamente amorfa. Após o tratamento térmico todas as fitas apresentaram as transformações martensíticas e auteníticas. Observou-se que a velocidade da roda tem grande influência nas temperaturas de transformação, chegando à variação de aproximadamente 7°C. O tratamento térmico remove todos os defeitos produzidos pelo processo de solidificação rápida e produz um rápido crescimento de grão, favorecendo ao aumento das temperaturas de transformação.

 

The shape memory effect (SME) is strictly related to the reversible martensitic transformation. Shape memory characteristics of Ti-37,8Cu-18,7Ni alloy ribbons prepared by melt spinning were investigated by means of differential scanning calorimetry (DSC) and X-ray diffraction. In these experiments particular attention has been paid to change of the velocity of cooling wheel from 21 to 63 m/s. Then the cooling rates of ribbons were controlled. The effect of this cooling rate on austenitic and martensitic transformations behaviors is discussed.the ribbon is produced at 63 m/s the amorphous structure without any crystal phases was observed. The ribbons of this alloy was subjected to annealing to a temperature of 700oC for 15 minutes. Thermal treatment removes all defects produced by rapid solidification process and produces a rapid grain growth and the increase of transformation temperatures.

Keywords

Ligas Ti-Ni-Cu; Memória de forma; Solidificação rápida

Ni-Ti-Cu alloy; Shape memory; Rapid solidification; Melt Spinning

How to cite

Walman Benicio de Castro; Alana Pereira Ramos; George Carlos dos Santos Anselmo. INFLUÊNCIA DO TRATAMENTO TÉRMICO NAS TEMPERATURAS DE TRANSFORMAÇÃO DE LIGA Ni-Ti-Cu SOLIDIFICADA RAPIDAMENTE COM EFEITO DE MEMÓRIA DE FORMA, p. 7208-7213. In: 69th ABM International Annual Congress, São Paulo - Brasil, 2014.
ISSN: 2594-5327, DOI 10.5151/1516-392X-24596