ISSN 2594-5327
61º Congresso Anual da ABM — Vol. 61, Num. 61 (2006)
Título
Autoria
DOI
Downloads
Resumo
Alguns restauradores usam, empiricamente, uma resina sintética na restauração de esculturas e prédios. A restauração do quartzito com uma resina consiste em colocar um catalisador na resina e misturá-la com um pó de pedra de coloração e granulometria mais próxima daquela que está deteriorada. E, ainda, passa-se a pasta nas duas superfícies, faz-se a sua junção e espera-se o tempo de cura. Com o objetivo de oferecer aos restauradores maiores informações sobre o comportamento estrutural do quartzito, colado com resina, e de ampará-los cientificamente, nesse trabalho foram realizados diferentes ensaios em corpos-de-prova (CPs) de quartzito. Os mesmos foram ensaiados com e sem cola, os resultados comprovaram que os CPs colados com as resinas suportaram os ensaios em flexão. Não foi, possível, porém, usar as resinas nos ensaios em compressão pois os CPS entram em colapso, e nem no ensaio de impacto de um corpo duro, pois o CP apresentou trincas que aumentaram cada vez mais em quantidade e tamanho, moldando-se à areia do caixote e não se rompendo. Constatou-se que o rompimento dos CPs nos ensaios em flexão ocorreu fora da região da resina, confirmando a boa resistência mecânica do CP colado.
Same restores use empirically a synthetic resin in the restoration of building and sculptures. The quartzite’s restoration with a resin consists in adding a catalyst and combining it with a powder of a stone which coloration and granulation are closer to the deteriorated one. In sequence, the paste produced is placed on both sides of the rock to make the joint, and it is put aside to cure, with the aim of offering the restores more information about the structural behavior of the quartzite, glued with resin, and of supporting them scientifically, it has been done different tests with quartzite specimen. The quartzite specimen were tested with and without glue, the result proved that the quartzite specimen glued with the resin were resistant to the tests of flexing. It was not possible, though, to use the specimen with resin on compression tests, because the specimen collapsed, nor in impact tests in hard body, since the specimen showed cracks that increased in size and length, modeling to the box’s sand without breaking apart. It was concluded that rupture of the specimen on the flexing tests not in the resin region, what confirmed the good mechanic strength of the specimen glued.
Palavras-chave
Quartzito Itacolomi; Resinas; Comportamento mecânico
Quartzite Itacolomi; Resins; Mechanical behavior
Como citar
Botaro, Vagner Roberto; Godefroid, Leonardo Barbosa; Cláudio, Luiz; Cândido, José Henrique Neves.
AVALIAÇÃO DA INTEGRIDADE ESTRUTURAL DO QUARTZITO ITACOLOMI EMPREGADO COMO ROCHA ORNAMENTAL,
p. 485-493.
In: 61º Congresso Anual da ABM,
Rio de Janeiro,
2006.
ISSN: 2594-5327, DOI 10.5151/2594-5327-2005-14254-0057